Post-requisites
1. Replace the
wireless
card.
2. Replace the
base
cover.
Power button with fingerprint reader
Removing the power button with fingerprint reader
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE:
Applicable only for computers that are shipped with fingerprint reader.
Prerequisites
1. Remove the
base
cover.
2. Remove the
I/O
board.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
Procedure
1. Remove the two screws (M2x3) that secure the power button with fingerprint reader from the palm-rest and keyboard assembly.
2.
NOTE:
This step is applicable only on the computers that are shipped with fingerprint reader.
Open the latch, and disconnect the fingerprint-reader cable from the power button cable connector.
3. Peel off the power button or power button with fingerprint reader from the palm-rest and keyboard assembly.
computer. After working inside your computer, follow the instructions in
Removing and installing components
After
37