Victron energy MultiPlus 12 3000 120-50 120V Service Manual page 15

Step 2: Exemplary settings
Example 1 is the factory setting (since factory settings are entered by computer, all DIP switches of a new product are set to 'off' and do
not reflect the actual settings in the microprocessor.).
DS-8 Ch. voltage off
DS-7 Ch. voltage on
DS-6 Absorpt. time on
DS-5 Adaptive ch. on
DS-4 Dyn. Curr. limit off
DS-3 UPS function: on
DS-2 Voltage on
DS-1 Frequency on
Step 2 Step 2
Example 1 (factory setting): Example 2:
8, 7 GEL 14,4V 8, 7 OPzV 14,1V
6 Absorption time: 8 hours 6 Abs. time: 8 h
5 Adaptive charging: on 5 Adaptive ch.: on
4 Dynamic current limit: off 4 Dyn. Curr. limit: off
3 UPS function: on 3 UPS function: off
2 Voltage: 120V 2 Voltage: 120V
1 Frequency: 50Hz 1 Frequency: 50Hz
To store the settings after the required values have been set: press the 'Down' button for 2 seconds (lower button to the right of the DIP
switches). The temperature and low-battery LEDs will flash to indicate acceptance of the settings.
The DIP switches can be left in the selected positions, so that the 'other settings' can always be recovered.
DS-8 off DS-8 on
DS-7 off DS-7
DS-6 on DS-6 on
DS-5 on DS-5 on
DS-4 off DS-4 on
DS-3 off DS-3
DS-2 on DS-2
DS-1 on DS-1 on
Step 2
Example 3:
8, 7 AGM 14,7V
6 Abs. time: 8 h
5 Adaptive ch: on
4 Dyn. Curr. limit: on
3 UPS function: off
2 Voltage: 120V
1 Frequency: 50Hz
DS-8 on
off DS-7 on
DS-6 off
DS-5 off
DS-4 off
off DS-3 on
off DS-2 off
DS-1 off
Step 2
Example 4:
8, 7 Tub.-plate 15V
6 Abs. time: 4 h
5 Fixed abs. time
4 Dyn. Curr. limit: off
3 UPS function: on
2 Voltage: 120V
1 Frequency: 60Hz
13