Advertisement
INSTALLER NOTE: Overtightening the Hanger
Rod nuts may cause the Door Brackets to
damage the door skin.
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
4.9
Torque both Lower Hanger
Rod Clamp bolts to 90 in-lbs.
4.6
Align the upper left Door
Bracket edge to the pencil
mark made during Step 4.1
Tighten Door Bracket bolt
until the Bracket is snug.
4.7
Adjust the bottom of the Ladder
until the bubble is centered in the
level. Further verify correct vertical
positioning by visually inspecting
the bottom pencil mark made
during Step 4.2
4.8
Tighten the Lower Hanger
Rod nut until the Door
Bracket's rubber isolator
begins to compress
Tighten Door Bracket bolt
until the Bracket is snug.
4.10
Remove the Hanger Rod
hardware and retain for
future adjustments.
7
Advertisement
