Advertisement
Assemble the right side Lower Bracket to the Ladder using the
2.4
indicated hardware. The bolts must screw into bolt holes #3,
and #5 of the Hanger Connector. Repeat Step 2.2 to attach the
right side Lower Bracket.
Push the Lower Bracket
down until the Bracket
2.5
Plate stops, and torque
Bolts to 90 in-lb.
3.2
Slide the Lower Mounting
Bracket Hanger Rods into
the Hanger Rod Clamps.
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
LOWER MOUNTING HANGER RODS
This Lower Mounting
Hanger Rod comes from
the factory pre-assembled.
It is necessary to remove
the tightening hardware
for installation into the
Hanger Rod Clamps as
seen in Step 3.2
#3
#5
Reinstall Hanger Rod
hardware removed
during Step 3.1
3.1
3.3
3.4
Do not tighten until
Steps 4.5-4.8
5
Advertisement
