Recommended Charge Leads, Polarity - GRAUPNER ULTRAMAT 15 Operating Manual

Liability exclusion
As manufacturers, we at GRAUPNER are not in a position to ensure that you observe the
correct methods of operation when installing, using and maintaining this charger. For this reason
we are obliged to deny all liability for loss, damage or costs which are incurred due to the
incompetent or incorrect use and operation of our products, or which are connected with such
operation in any way.
4. Recommended charge leads /polarity
The requirements made on rechargeable batteries vary greatly according to their particular
application, and this in turn calls for different types of battery connector. Please note that
connectors, connector names and polarities may vary from one manufacturer to another. For
this reason we recommend that you always use genuine matching connectors of identical
construction. The following charge leads are suitable for battery charging with this unit:
Japan
Order No. 3371
Be sure to use genuine charge leads fitted with cable of adequate conductor cross-section.
All charge leads should be cut down to a maximum lenght of 30 cm.
5. Charger controls / Using the charger / Starting the process
Screen
Connectors for
12...15V DC
power supply
pr car battery
+
Car battery
terminal clips
All the charger's functions are controlled by means of just four buttons.
The - / DEC and + / INC buttons are used to change the current and voltage values. The function
of the other two buttons varies according to the presence or otherwise of a battery at the charge
sockets:
Bedien-Taste
No battery PROGRAMM/MODE Select charge programs and sub-groups
connected: ENTER/START
Battery PROGRAMM/MODE Ends the charge process, stops the buzzer
connected: ENTER/START
G2 (AMP/G2,5)
Order No. 3011 Order No. 3037
-
Funktion
Select the (charge) program group
Starts the charge process, changes
BEC
Order No. 3021
fan
Operating buttons
JR JR-Sender
Order No. 3022
21