Larson Electronics EXPCMR-CER-IP-POE-4MP-IR-FLX.23-JB.3.SFC User Manual page 46

Detection Mode: Grid
1. Click Setup > Events > Common Alarm > Motion Detection > Detection Mode > Grid.
2. Set desired detection area(s) on the grids. Irregular detection areas are allowed.
3. Set detection sensitivity.
4. Set the alarm parameters.

Suppress Alarm(s): After an alarm is triggered, the same alarm will not be reported within
the set time.

Clear Alarm(s): After an alarm is triggered,
A. If the same alarm is not triggered within the set time, the alarm will be cleared and the
same alarm can be reported again.
B. If the same alarm is triggered within the set time, the alarm will not be cleared until the
suppress alarm time expires. Then the same alarm can be reported again.
5. Set actions to be triggered by motion detection alarm and the plan.
6. Click Save.
46