Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
For access, do the following:
1. Remove the power cord and ac power adapter. See "Power cord and ac power adapter" on page 49.
2. Remove the smart cable clip. See "Smart cable clip (for selected models)" on page 49.
3. Remove the hinge cover. See "Hinge cover" on page 50.
4. Remove the computer stand. See "Computer stand" on page 51.
5. Remove the optical drive. See "Optical drive" on page 52.
6. Remove the computer cover. See "Computer cover" on page 53.
7. Disconnect the optical drive board cable.
Removal steps
Power switch board
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
For access, do the following:
1. Remove the power cord and ac power adapter. See "Power cord and ac power adapter" on page 49.
2. Remove the smart cable clip. See "Smart cable clip (for selected models)" on page 49.
3. Remove the hinge cover. See "Hinge cover" on page 50.
4. Remove the computer stand. See "Computer stand" on page 51.
5. Remove the optical drive. See "Optical drive" on page 52.
6. Remove the computer cover. See "Computer cover" on page 53.
.
Chapter 6
Hardware removal and installation
61