Installing A Side Option - ABB ACS480-04-09A8-1 Hardware Manual

Note: If you have the BIO-01 option module, you can add one additional fieldbus module
on top of it.
￭

Installing a side option

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur. If you are not a qualified electrical
professional, do not do installation or maintenance work.
1. Do the steps in section
work.
2. Remove the two screws from the front-most grounding clamp at the bottom of the
drive.
3. Carefully align the side option with the connectors on the right side of the drive.
4. Fully push the option module into position.
5. Torque the screw on the option module to 1 N·m (8.8 lbf·in).
4
Electrical safety precautions (page 18)
Electrical installation – IEC 87
5
before you start the
6