Table of Contents
Advertisement
7. Lift the left side of the desk assembly (D).
Connect the Upright Wire (93) to the Console
Wire (97). The connectors should slide
together easily and snap into place. If they
do not, turn one connector and try again. IF
YOU DO NOT CONNECT THE CONNECTORS
PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE
POWER.
8. Tighten two 3/8" x 1 1/2" Screws (3) with two
3/8" Star Washers (2) into the desk assembly (D)
as shown. Make sure that the bracket on top
of the Inner Left Upright (63) slides between
the Desk Support Frame Cover (87) and the
Desk Support Frame (88). Insert the wires
into the top of the Inner Left Upright. Make
sure that no wires (E) are pinched.
See step 6. Fully tighten the two 3/8" x 1 1/2"
Screws (3) on the right side.
7
D
97
8
87
88
63
2
3
11
93
E
D
2
3
Advertisement
Table of Contents
