Table of Contents
Advertisement
5. Set the console assembly (A) face down on a
soft surface to avoid scratching the console.
Next, lay the Desk Frame (77) onto the con-
sole assembly (A) as you insert the 24" Ground
Wire (96), the Console Wire (97), and the post
(B) through the hole (C) in the Desk Frame.
Note: It may help to turn the connector on the
Console Wire to a vertical position when you
insert it into the post.
Note: If the 1" Plastic Bushing (90) comes out,
press it back in.
See the inset drawing. Slightly twist and slide
the 1" Ring (5) down onto the post (B). Make
sure that the Ring is securely inserted into the
grooves in the post. Then, connect the two
Ground Wires (95, 96).
6. With the help of a second person, set the right
side of the desk assembly (D) onto the Inner
Right Upright (65). Make sure not to pinch any
wires on the left side.
Partially tighten two 3/8" x 1 1/2" Screws (3) with
two 3/8" Washers (2) into the desk assembly (D)
as shown. Make sure that the bracket on top
of the Inner Right Upright (65) slides between
the Desk Support Frame Cover (87) and Desk
Support Frame (88). Do not fully tighten the
Screws yet.
5
C
96
97
A
5
96
B
6
D
65
3
10
77
90
B
95
88
87
2
3
Advertisement
Table of Contents
