Table of Contents
Advertisement
Quick Links
GAS COOKER
INSTRUCTION MANUAL
Model num ber: RHGC1
Please read these instructions carefully and
keep them for future reference
For Customer Services, Spare Parts & Warranty Information
please call 0845 683 8717
Opening times: Monday - Friday 8am until 8pm
Saturday & Sunday 10am until 4pm
Get other manuals https://www.bkmanuals.com
Advertisement
Table of Contents
Related Manuals for Russell Hobbs RHGC1
Summary of Contents for Russell Hobbs RHGC1
- Page 1 GAS COOKER INSTRUCTION MANUAL Model num ber: RHGC1 Please read these instructions carefully and keep them for future reference For Customer Services, Spare Parts & Warranty Information please call 0845 683 8717 Opening times: Monday - Friday 8am until 8pm Saturday &...
- Page 2 Before operating your new appliance please read this instruction manual carefully. It contains important information concerning the safe installation and operation of the appliance. Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.
-
Page 3: Table Of Contents
CONTENTS: 1. BRIEF PRESENTATION OF PRODUCT 2. WARNINGS 3. INSTALLATION AND PREPARATIONS FOR USE 3.1 Environment where the appliance is to be installed 3.2 Installation of product 3.3 Adjustment of feet 3.4 Gas connection 3.5 Electric connection and safety 3.6 Gas conversion 4. - Page 4 Gas Cooker FREE-STANDING COOKERS SPECIFICATION SHEET RHGC1 Nominal Dimensions Height (Adjustable Feet max. +3.5cm) Width Depth Hob Features Enamel Rapid Gas Burner Ø10cm 3000 Semi-rapid Gas Burner Ø7.5cm 1750 Auxiliary Gas Burner Ø5.5cm 1000 Burner Safety Valves Button Ignition Enamel Pan Supports...
-
Page 5: Brief Presentation Of Product
1. BRIEF PRESENTATION OF PRODUCT List of Components: Cooker top 9- Oven Lamp 2- Control Panel 10- Semi-Rapid Burner 3- Oven Door Handle 11- Rapid Burner 4- Adjustable Feet 12- Auxillary Burner 5- Oven Door 13- Pan Support 6- Oven Tray 14- Semi-Rapid Burner 7- Wire Grid 8- Grill Pan and Handle Set... -
Page 6: Warnings
2. WARNINGS General Safety • These warnings are provided in the interest of your safety. Read this manual carefully before using the appliance. • This appliance has been designed for non-professional, domestic use only. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Page 7 During Use • When you first run your oven a certain smell will be emanated arising from the insulation materials and the heater elements. For this reason, before using your oven, run it empty at maximum temperature for 45 minutes. At the same time you need to properly ventilate the environment in which the product is installed.
- Page 8 • Pay attention to the cables of the other electrical devices operating near the appliance, so as not to touch to hot points. • The appliance is not intended to be operated by means of an external timer or separate remote control system. •...
-
Page 9: Installation And Preparations For Use
3. INSTALLATION AND PREPARATIONS FOR USE ● Before operating your new appliance please read this instruction manual carefully. It contains important information concerning the safe installation and operation of the appliance. ● Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved. - Page 10 The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50 °C above room temperature.
-
Page 11: Adjustment Of Feet
3.3 Adjustment of feet Your product stands on 4 adjustable feet. When the product is placed where it is to be used, check if the product is balanced. If it is not balanced, you can make the adjustment by turning the feet clockwise if required. - Page 12 The points that must be checked during fixed gas connection assembly During connections always keep the nut on the gas manifold fixed, while rotating the counter-part. Use spanners of appropriate size for safe connection. For all surfaces between different components, always use the seals provided in the gas conversion kit.
-
Page 13: Gas Conversion
IMPORTANT: How to wire a 13 amp plug The wires in the mains lead on this appliance are coloured in accordance with the following code: • Green and Yellow – Earth Earth (Green-Yellow) • Blue – Neutral Fuse (3 Amp) Neutral (Blue) Live (Brown) •... - Page 14 Spanner Injector Figure 10 Figure 9 Oven/Grill Injectors The oven and grill injectors are assembled by a single screw that is placed on the tip of the burner. For grill burners, this screw is already visible(Figure 11). Remove the screw, pull the grill burner to yourself and you will see the injector revealed on the rear surface of the oven cavity (Figure 12).
- Page 15 To determine the minimum position, ignite the burners and leave them on in minimum position. Remove the with the help of a small screwdriver fasten or loosen the bypass screw around 90 angular degrees. When the flame has a length of at least 4mm, the gas is well distributed. Make sure that the flame does not die out when passing from the maximum position to the minimum position.
-
Page 16: Use Of Your Product
4. USE OF YOUR PRODUCT 4.1 Use of gas burners Ignition of the burners To determine which knob controls which burner, check the position symbol above the knob. • Manual Ignition of the Gas Burners If your appliance is not equipped with any ignition aid or in case there is a failure in the electric network, follow the procedures listed below For Hob Burners: To ignite one of the burners, press and turn its knob counter- clockwise so that the knob is in maximum position, then press the ignition button... -
Page 17: Control Of Hob Burners
Flame safety device: Hob Burners This hob is equipped with flame failure device provide security in case of accidentally extinguished flame. If such a case occurs, the device will block the burners gas lines and will avoid any accumulation of unburned gas. Wait 90 seconds before re-igniting an extinguished gas burner Oven / Grill Burners Regardless of the model of your appliance, all oven burners are equipped with a gas safety device. -
Page 18: Control Of Oven Burner
Your hob has burners of different diameters. The most economic way of using gas is to choose the correct size gas burners for your cooking pan size and to bring the flame to minimum position once the boiling point is reached. It is recommended to always cover your cooking pan. - Page 19 Do not operate the appliance between "Off" position and first temperature marker in the counter-clockwise direction. Always use the oven between maximum and minimum numbers. When turning the oven off, turn the knob in the clockwise direction so that the knob shows "0" position. RHGC1 POSITION TEMPERATURE 270 C MAX.
-
Page 20: Control Of Grill Burner
4.1.3 Control of the grill burner CAUTION: Accessible parts may be hot when the grill is in use. Young children should be kept away. Right after you ignite the burner, place the grill heat deflector under the control panel. After that, lift the oven door up slowly until it stops at the semi-open (30 °) position and touches the heat shield. -
Page 21: Use Of Mechanical Minute Minder
• Never cover the grill pan or grid with foil as this can lead to grill fires. • If your appliance has a grill pan and handle set as an accessory, refer to accessories section for its usage. WARNING: Ensure that the grill is turned off before closing the door. 4.1.4. - Page 22 Oven Cavity Rack positions for molded racks 6. Rack 5. Rack 4. Rack 3. Rack 2. Rack 1. Rack Oven Accessories * The accessories of your oven may be different due to the model of your product. Wire grid Wire grid is used to grill or to place different cookwares on it. To locate the wire grid correctly in the cavity, put it to any rack and push it up to the end.
-
Page 23: Cleaning And Maintenance
5. CLEANING AND MAINTENANCE 5.1 Cleaning Be sure that all control switches are off, your appliance cooled and the appliance is unplugged before cleaning your oven. Check whether the cleaning materials are appropriate and recommended by the manufacturer before using the cleaning materials on your oven. - Page 24 Cleaning of Gas Cooker - Hob Part • Ensure all switches are off, your appliance cooled and the appliance is unplugged before cleaning. • Lift up the pan supports, caps and crowns of hob burners. • Wipe and clean the back panel with a soapy cloth. •...
-
Page 25: Maintenance
Burner Caps: Periodically, enameled pan support, enameled covers, burner heads must be washed with soapy warm water rinsed and dried. After drying them thoroughly, replace them correctly. Enamelled Parts: In order to keep them as new, it is necessary to clean them frequently with mild warm soapy water and then dry with cloth. -
Page 26: Service And Transport
6. SERVICE AND TRANSPORT 6.1 Basic troubleshooting before contacting service If the oven does not operate : • The oven may be unplugged or switched off at the plug. • There has been cut off at power and the fuse box/switch needs to checked. If the oven does not heat : •... - Page 27 INJECTOR TABLE Gas Category: II 2H3+ 28-30 mbar 20 mbar RAPID BURNER Injector Diameter (%mm) Nominal Rating (kW) 2.75 Consumption in 1h 218.1 gr/h Consumption in 1h 285.7 lt/h (at 15 C and 1013mbar pressure) SEMI-RAPID BURNER Injector Diameter (%mm) Nominal Rating (kW) 1.75 1.75...
- Page 28 For Customer Services, Spare Parts & Warranty Information please call 0845 683 8717 Opening times: Monday - Friday 8am until 8pm Saturday & Sunday 10am until 4pm Customer Service Department Picktree Court Picktree Lane Chester-le-Street Co Durham DH3 3SY Revision 1 This symbol is known as the 'Crossed-out wheelie bin Symbol'.
Need help?
Do you have a question about the RHGC1 and is the answer not in the manual?
Questions and answers