Mounting Hole Specifications; Volume Adjustment; Sound Setting - Qlightec STND Series Quick Start Manual

Mounting Hole Specifications

• Machine holes on the mounting surface
referring to the diagram on the right.
Min.Ø5 CABLE ENTRY
3-Ø6 HOLES
STND125LR-N/ STND125L-N/ STND125R-N
Front Cover Removal Instructions
• To access the control panel, remove the front cover by
unscrewing the M3 bolts on the front cover.
Front Control Configuration
Sound switch
• The volume output of this product is adjustable.
• Turn the volume dial clockwise to increase the volume, and turn
• There will be no sound when the dial is put at MIN.
PCD70
Volume switch
■ Select built-in Bit sound group or Binary sound group
4

Volume Adjustment

counter clockwise to decrease the volume.
MAX.

Sound Setting

• Built-in sounds can be selected by using
a switch either bit or binary sounds.
• Please be conscious of the number selected
for your desired sound option.
- Switch No. 1 : Select Bit or Binary
- Switch No. 2,3,4 : Select Built-in sound group
■ Select built-in Bit sound group
• It is being used when built-in sound is selected.
• Select between the six sound groups.
• Every group has 5 type of sounds.
How to select bit type sound group
ON(1)
OFF(0)
No. 2 3 4
1 0 0 1
5 Warning Sounds
2 0 1 0 5 Special Warning Sounds (1st Group)
3 0 1 1
5 Melodies
4 1 0 0 5 Alarms
5 1 0 1
5 Special Warning Sounds (2nd Group)
6 1 1 0 5 Special Warning Sounds (3rd Group)
• In bit input mode, Please set switch no.1 to
off(0).
• In binary input mode, Please set switch no.1
to ON(1).
Volume Dial
MIN.
VOL.
Sounds