Qlightec STND Series Quick Start Manual page 3

Signal/ waring lights with built-in sounder
Table of Contents

Advertisement

Parts Definition/ Installation
STND125L-N
Lens(AS)
Reflector
(Heat resistant ABS)
LED unit
Cover connector
(ABS)
Control panel cover
(ABS)
Resonance chamber
(ABS)
Housing(ABS)
Rubber spacer
Flange nut
• First, remove the flange nuts from bolts and place the product through the mounting surface holes.
• Fasten the flange nuts on the opposite side of the mounting surface until the product is tightened securely.
Bit/ Binary Input Method Depending on Wiring Method
■ Bit Input Mode
• Bit input mode(using external line) allows you to select
one of five sound options by switching on one of the 5
channels (Ch1 - Ch5).
• Total of 5 sound options are configurable.
■ Binary Input Mode
• Binary input mode(using external line) allows you to
receive multiple inputs by using the 5 channels
(Ch1 - Ch5) to configure one of 30 sound options.
• Total of 30 sound options are configurable.
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP54.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indica-
ted(IP54), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright or horizontal position. Do not install the product upside-down or in
positions where water can potentially penetrate into the product and impact its operation.
• For further information, please visit our website(www.qlight.com).
STND125LR-N
LED unit
The channel selection method
using a transistor is the same
as the external contact method,
please refer to the figure on
the right.
The switch figure to the right
explains how to wire the exter-
nal contacts of a signal line
product. If the product is not a
signal line product, use the
channel selection switch attached
inside the product.
Bit Input Mode
Can select up to 5 sound options
Binary Input Mode
Can select up to 30 sound options
3
STND125R-N
Light bulb
Ch 1 Ch 2 Ch 3 Ch 4 Ch 5
COM
Ch1 Ch2 Ch3 Ch4 Ch5
ON(1)
OFF(0)
No.
1
2
3
4
5
0
0
0
0
0
0
1
1
0
0
0
0
2
0
1
0
0
0
3
0
0
1
0
0
4
0
0
0
1
0
5
0
0
0
0
1
0
0
0
0
0
0
1
0
0
0
0
1
2
0
0
0
1
0
29
1
1
1
0
1
30
1
1
1
1
0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stnd125-nStnd125lr-nStnd125l-nStnd125r-nStnd125r-n-dcStnd125r-n-ac ... Show all

Table of Contents