How To....
Replace the Heart Rate Board (Model E3 only)
Tools Required: Phillips screwdriver
Estimated Repair Time: 15 Minutes
1. Remove the Activity Zone Cover.
2. Disconnect the cables from the
Heart Rate Board that is attached
with tape to the inside of the Activity
Zone Cover.
3. Pry the Heart Rate Board off the
plastic.
4. Replace with new board and new
tape in the same position on the
Activity Zone Cover.
5. Reconnect the cables and replace
the Activity Zone Cover.
Replace the Upright Covers (Model E3 only)
Tools Required: Phillips Screwdriver
Estimated Repair Time: 15 Minutes
1. Remove and save the four Phillips screws that secure the left or right upright cover to the frame.
2. Install new upright cover using the screws removed in step 1.
Back of
Accessory Tray
Upright Cover
Upright Cover Screws
19
Tape
Heart Rate
Board
(4 per cover)