Failures In The Pitt ® Cooking System - PITT Outdoor kit User Manual

8 Failures in the PITT
Note: the PITT cooking-system may only be connected by an approved installer. To ensure the safety and warranty
®
repairs may only be performed by approved professionals. You should only use original parts.
Failure Cause
A burner ignites and The control knob is not pressed
turns off again. long enough to activate the auto-
flame detection.
The control knob is not adjusted at
the correct height.
The control-button Hob is not mounted the right way
touches the sealing under the countertop.
scale.
Sealing scale is not in the center
vs. control knob.
Spark ignition Hob is not mounted the right way
remains igniting. under the countertop.
Sealing scale is not in the center
vs. control knob.
The burner doesn't The control knob is not adjusted at
ignite. the correct height.
The power plug is not in the power
socket.
Fuse malfunction / fuse in meter
cupboard is disabled.
Spark ignition is dirty or wet.
Burner parts are not properly
mounted.
Burner parts are dirty or wet.
The main gas supply is not open.
The control knob is not pressed
long enough
Battery empty*
A burner does not Burner parts are not placed
burn evenly. properly.
Burner parts are dirty or wet.
Gas smell. Gas connection leaks.
There is a burner turned on, but
not inflamed.
* Depending on the model
** TS = PITT cooking Top Side manual
®
If the failure still remains please contact your dealer or the PITT
cooking system
®
Solution
Press the control knob down
long enough to turn between full
and low heat.
Adjust the control knob properly. Installation manual
Adjust the control knob properly. Installation manual
Detach sealing scale and and
re-stick again.
Adjust the control knob properly. Installation manual
Detach sealing scale and and
re-stick again.
Adjust the control knob properly. Installation manual
Put the power plug into the
power socket.
Install a new fuse or switch on
the fuse again.
Clean or dry the spark ignition.
Ensure the burner parts are
correctly aligned with the
centring cams.
Clean or dry the
burner parts. Make sure the
outflow holes are open.
Open the main gas supply.
Press the control knob down
long enough to turn between full
and low heat.
Replace battery
Ensure the burner parts are
correctly aligned with the
centring cams.
Clean or dry the
burner parts. Make sure the
outflow holes are open.
Check the connection. Turn main
gas supply off immediately when
you're not able to fix it right
away.
Close the control knob and wait
a few minutes before reigniting.
cooking customer service. See contact details on page 23.
®
21
Chapter / Page
Chapter 4 / page 18
TS**: 13 t/m 15
TS**: 13 t/m 15
Installation manual
TS**: 19 t/m 20
TS**: 13 t/m 15
Installation manual
TS**: 19 t/m 20
TS**: 13 t/m 15
Chapter 6 / page 19
Chapter 6 / page 19
Chapter 6 / page 19
Chapter 4 / page 18
Chapter 2 / page 16
Chapter 6 / page 19
Chapter 6 / page 19
Chapter 4 / page 18
EN