Using The Remote Control That Has 6, 10 Or 16 Function Buttons - NRC 30CS Operation And Maintenance Manual

3.12 Using the remote control that has 6, 10 or 16 function
buttons
This type of remote control is used to control the vehicle as you do with the control panel, but
allows you to move around to better see what you are doing and to be in a safer place while you
operate the wrecker.
3.12.1 Pairing the remote control with the receiver
To pair the remote control with the receiver, proceed as follows:
1. Turn the ignition key OFF or disconnect the power to the receiver.
2. Turn the ignition key ON or reconnect the power to the receiver. This opens a 20-second
window in the receiver processor. If you are looking at the receiver's printed circuit board,
which is located on the front panel of the wrecker body, you will see the fault LED
flashing.
3. During these 20 seconds, press and hold the remote control Reset button for five
seconds. When the transmitter and remote control are paired, the fault LED is illuminated
continuously.
3.12.2 Operating the remote control
1. Push and hold the green button on the remote control.
2. Start using the remote control. Note that each remote control is built and programmed
according to your requirements.
Composite Slider Wreckers – Operation and Maintenance
Models: 30CS-40CS-50CS
O p e r a t i o n a n d M a i n t e n a n c e
97
REV. 1
APRIL 12, 2023