Checking The Pto - NRC 30CS Operation And Maintenance Manual

5.3

Checking the PTO

1. Ensure that the hydraulic pump is working.
2. Verify that there is power in the control box. You can try to activate the toggle switch
located outside the control box on the left side (the control box is in the left standard
toolbox). This switch should route the electrical power to the computer.
This is only a temporary solution. The cause of the problem must be found immediately. Turn off
the toggle switch as soon as possible.
Composite Slider Wreckers – Operation and Maintenance
Models: 30CS-40CS-50CS
O p e r a t i o n a n d M a i n t e n a n c e
134
REV. 1
APRIL 12, 2023