Connecting Via Network - Vimar by-me 01945 Installer Manual

Installation

1.2 Connecting via Network

The configuration and use of the Web Server include a link to your home or business.
The network parameters of the Web Server will be set according to the configuration of the LAN which must host it.
For the initial configuration of the Web Server, as well as in the absence of a network during installation, you must proceed as follows:
• Connect the Web Server to the PC through a "cross-over" (or "cross") Ethernet cable
• Access to the network configurations of the PC, as shown in the documentation for your operating system
• Change the settings of the TCP/IP (version 4) communication protocol relating to the LAN port that is connected to the Web Server, and manually
set the following parameters:
- IP Address: 192.168.0.0.100
- Netmask: 255,255,255.0
- Default gateway: 192.168.0.110
• Save and wait for the new settings to take effect. If required, restart the system.
The following figures show, for example, the network configuration windows for a PC with Windows 7 operating system.
After these operations, open an Internet browser and type in the address bar, as follows:
http://192.168.0.110
9