Table of Contents
Advertisement
Installation
1. Installation
1.1 Mounting and connections
The Web Server is designed to be mounted on standard DIN rail. For the correct operation of the Web Server it is necessary to provide the follow-
ing connections:
• 12V DC power supply by connecting, through a special terminal provided, the power supply art. 01830.
• By-me bus using the special terminal provided
• LAN network via cable via cat. 5 or higher and standard RJ45 connector
The front LED marked as "POWER" indicates the presence of power, while the "FUNCTION" LED is normally off, except to point out special opera-
tions in progress.
The Web Server also provides the following ports:
• SD Slot: available for future applications
• USB Slot: available for future applications
12V-30V= BUS
NOTE: connection to the By-me bus is not essential to the configuration of the Web Server; however, it is preferable because in its
absence is not possible to check its correct operation.
Art. 01946 can manage up to 64 By-me devices (control panel art. 21509 included). The devices to be counted are only all those with a
+ - BUS terminal.
The Web Server (art. 01945-01946) can support a maximum of 1 load control module art. 01455.
1.1.1 Management of SD card by the Web Server
The Web Server has a slot for inserting an SD memory card.
The slot is a "push-push" type.
SD card compatibility characteristics
Compatible SD cards: SD, SDHC.
Format: FAT32
Inserting the SD card
The procedure for inserting the SD card in the Web Server is as follows:
1. Disconnect the power supply to the Web Server
2. Insert the SD card into the dedicated slot on the Web Server, with the direction indicated on the label on the device. The card must be pushed
into the docked position in the slot.
3. Reconnect electrical power to the Web Server
IMPORTANT: If the SD card is inserted with the Web Server powered on, it will not be usable on the Web Server.
Removing the SD card
The procedure for removing the SD card from the Web Server is as follows:
1. Disconnect the power supply to the Web Server
2. Push the SD card in to release the card from dock and proceed with the extraction of the SD card .
3. Reconnect electrical power to the Web Server
01945
WEB SERVER
By-me
RESET
CARD
SD
FUNCTION
POWER
7
Advertisement
Table of Contents
