Updating The Firmware - XMOS VocalFusion XVF3510 User Manual

3.8. UPDATING THE FIRMWARE

As described above the hardware used on both development kits are identical allowing both firmware
variants, -UA and -INT to operate correctly on either kit. The following steps should be used to update
the firmware on the device.
1. Download the xTIMEcomposer tools from
system that will be connected to the board to perform the update.
2. Download the latest version of the required XVF3510 Release Package from
https://www.xmos.com/software/vocalfusion. At the time of writing v4.0 is the latest released
version.
3. Connect the XTAG Debugger to the system using the micro USB connection, plug the
debugger into the XTAG connector, marked 'DEBUG ONLY', and power the board using
micro USB connection marked USB on the XMOS processor board. (The power can be
supplied via a USB connection from the system used to update, or a Raspberry Pi if used).
The positions of these connectors are shown in the figure below:
Figure 3-3 Location of Debug and power connectors on XVF3510 Development Kit Processor Board.
4. Open up an 'xTIMEComposer Command Prompt', or configure a terminal window using the
appropriate setEnv script defined for the platform. For further information please consult the
XM-014232-PC
http://www.xmos.com/tools and install onto the
18