Troubleshooting - ICON Health & Fitness NordicTrack Club Reflex User Manual

Table of Contents

Advertisement

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 13). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 13. IMPORTANT: The treadmill is not
compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch pro-
trudes as shown, the circuit breaker has tripped. To
reset the circuit breaker, wait for five minutes and
then press the switch to the reset position.
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch to the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. The incline system may need to be calibrated. To initiate the calibration routine, switch the
reset/off circuit breaker to the off position, wait 5 seconds, and then switch the circuit breaker back
to the reset position. During the calibration routine, the treadmill will automatically travel to the high-
est incline level and then return to the initial level.
b. If the incline system still does not function properly, please see the front cover of this manual.
All manuals and user guides at all-guides.com
26
c
Tripped
Reset

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntl29008.0

Table of Contents