Page 1
User Manual and Product Specifications DC 85X & DC 130X 12/24V Fridge/Freezer DC-X Series Fridges Read user manual before operating your fridge/freezer DC50-X • DC65-X • DC85-X • DC130-X | For more information visit www.CaravanMods.com.au | (02) 9806 3055 |...
Congratulations on your purchase of a Bushman DC-X fridge. Please read these instructions carefully before installation and use. Please be safe and use common sense and caution when installing, operating and cleaning this appliance. If you are unsure about any of these instructions, contact your local stockist before proceeding.
Page 3
INSTALLATION INTO A CAVITY Refer to the following table for the recommended cut-out dimensions. If you are using the mounting kit, allow an extra 5mm width for the mounting kit frame and screws. MODEL CUT-OUT CAVITY DIMENSIONS (MM) WIDTH DEPTH HEIGHT DC50-X DC65-X...
Page 4
10. Reaffix the door handle using the original screws. 11. Reapply the logo sticker onto the door handle by applying moderate heat to the sticker. 12. Use the supplied DC-X Series sticker to cover the old screw holes. REPLACING THE FRONT DOOR PANEL Follow steps 1 to 2 under “Moving the door handle”...
Page 5
ADJUSTING THE DOOR LATCH Whenever the door or hinges have been moved, please adjust the top metal rail that the door latch clips under. Loosen the screws and move the top metal rail towards the rear of the fridge cabinet until the plastic door latch just makes light contact.
Page 6
| For more information visit www.CaravanMods.com.au | (02) 9806 3055 |...
Page 7
| For more information visit www.CaravanMods.com.au | (02) 9806 3055 |...
Page 8
| For more information visit www.CaravanMods.com.au | (02) 9806 3055 |...
Bushman printed installation and operating instructions. To obtain service under this warranty, the defective product must be returned to Bushman together with a copy of the original purchase receipt. Any product repaired or replaced under this warranty will be warranted for the balance of the warranty period with respect to the original purchased product.
TROUBLESHOOTING GUIDE Please check each of these 4 points. All 4 need to be right for your fridge to operate correctly. 1. VOLTAGE The most common cause of an incorrectly functioning fridge, or a fridge that starts and stops and doesn’t get cold, is a lack of consistent voltage.
RED LED ERROR LIGHT From mid 2021 onwards all Bushman DC-X series are fitted with a red LED error light. • Mid 2021 – mid 2022 the red LED is located on the compressor module. • Mid 2022 onwards the red LED is located inside the interior light housing.
Page 12
NOTES For after sales service and enquiries, please contact: Bushman Fridges 3 Contour Close Research VIC 3095 (03) 8080 9990 info@bushman.com.au Version 3.4 Dec 2022 | For more information visit www.CaravanMods.com.au | (02) 9806 3055 |...
Need help?
Do you have a question about the DC-X Series and is the answer not in the manual?
Questions and answers