Bushman DC-X Series User's Manual & Operating Instructions
Hide thumbs
Also See for DC-X Series:
- Owner's manual & operating instructions (12 pages) ,
- Owner's manual & operating instructions (12 pages) ,
- Owner's manual & operating instructions (8 pages)
Subscribe to Our Youtube Channel
Related Manuals for Bushman DC-X Series
Summary of Contents for Bushman DC-X Series
- Page 1 User Manual & Operating Instructions User Manual and Product Specifications DC 85X & DC 130X 12/24V Fridge/Freezer DC-X Fridges Read user manual before operating your fridge/freezer CARAVAN – MARINE – RV - OFFGRID...
-
Page 2: Installation
Congratulations on your purchase of a Bushman DC-X fridge. Please read these instructions carefully before installation and use. Please be safe and use common sense and caution when installing, operating and cleaning this appliance. If you are unsure about any of these instructions, contact your local stockist before proceeding. - Page 3 INSTALLATION INTO A CAVITY DC-X fridges are designed to be installed in a cavity. A gap of minimum 40mm is recommended for the rear. Refer to the following table for the recommended cut-out dimensions. If you are using the mounting kit, allow an extra 5mm width for the mounting kit frame and screws.
- Page 4 CLEANING Wash the inside of your fridge with luke warm water and a mild soap. Never use abrasive or corrosive cleaning agents, steel wool or scouring sponges. A soft sponge, towel, or soft brush is recommended. Always keep the inside of the fridge clean and dry. Remove any condensate water or ice which gathers in or near the tray under the freezer compartment.
-
Page 5: Rubber Seals
Reapply the logo sticker onto the door handle by applying moderate heat to the sticker. Use the supplied DC-X Series sticker to cover the old screw holes. Check that the plastic door latch is flush with the top metal rail when the door is closed. If there is more than 1- 2mm of movement, you will need to adjust the position of the top metal rail. -
Page 6: Troubleshooting
TROUBLE SHOOTING VOLTAGE The most common cause of an incorrectly functioning fridge is a lack of voltage. Your fridge has built in battery protection and needs the following minimum voltage for the compressor to start (Cut- in) or stop (Cut-out). Battery Protection Settings VOLTAGE CUT OUT... - Page 9 VENTILLATION OPTIONS DC-X min 200cm Exterior Ventilation min 40mm min 40mm min 150mm min 40mm Interior Ventilation Option 1 Interior Ventilation Option 2 min 40mm min 200cm min 150mm min 40mm Interior Ventilation Option 3 Interior Ventilation Option 4...
- Page 10 NOTES...
-
Page 11: Warranty
Bushman printed installation and operating instructions. To obtain service under this warranty, the defective product must be returned to Bushman together with a copy of the original purchase receipt. Any product repaired or replaced under this warranty will be warranted for the balance of the warranty period with respect to the original purchased product. - Page 12 For after sales service and enquiries, please contact: Bushman Fridges 3 Contour Close Research VIC 3095 (03) 9437 0737 info@bushman.com.au...
Need help?
Do you have a question about the DC-X Series and is the answer not in the manual?
Questions and answers