Solving Hardware Problems - HP Linux workstation x1100 Getting Started Manual

Table 3-1
Chapter 3

solving hardware problems

This table gives basic troubleshooting tips. For more in-depth
information, see the section "hp Diagtools hardware diagnostics" in this
manual.
Your Workstation Does Not Start Properly
The Workstation doesn't power on.
Make sure...
The workstation's power cord is
properly connected.
There is a buzzing noise.
A beep code when the workstation starts up means that there is a
configuration problem.
Make sure...
This is the pre-boot diagnostics
capability feature. It detects
problems with your workstation.
If you still have a problem, run HP e-Diagtools or Diagtools (refer to
page 65).
There is no image during boot and the screen is blank.
Make sure...
The line voltage switch, located
on the back of your workstation,
is set to 115.
If the Workstation starts and you still have a problem, run HP
e-Diagtools (refer to page 65).
troubleshooting your workstation
solving hardware problems
How
Connect the power cord to a
working power outlet and to the
rear of the workstation.
How
1. Count the number of beeps
after the buzzer (refer to the
section "pre-boot diagnostics
audio signal" in this chapter).
2. Contact HP Support (refer to
page 68).
How
See the section "screen is blank
because the system failed to boot"
in this chapter.
59