Tripp Lite AG-05F3 Series Owner's Manual page 25

Features
C13
Power Status LED (Switched Models Only): Green
LEDs illuminate to indicate power is present on each
outlet. Flashing LED means the pseudo-breaker is
activated.
Circuit Breaker (Select Models): There are 3 Load
Banks, each protected by a circuit breaker. If the
connected equipment load exceeds the Maximum Load
Rating for those banks of the PDU, the circuit breaker
will trip. Disconnect excess load and reset the breaker.
Push-to-Reset
Guard
Note: Each breaker comes equipped with a push-to-reset
guard to prevent accidental breaker tripping. To turn off the
breaker, insert a flathead screwdriver into the reset slot.
Mounting Brackets: Use these brackets as an
alternate PDU mounting method.
Mounting Buttons: Located on the back side of the
PDU, the pre-installed buttons are used for toolless
mounting.
Note: Four additional mounting buttons are included for
alternate rack styles.
PDUMVROTATEBRKT Mounting Accessory: Use these
L-shaped brackets to mount the PDU with its outlets
facing the rear of the rack.
Ground Screw: Use this to connect any equipment that
requires a chassis ground.
Outlets: During normal operation,
the outlets distribute AC power to
connected equipment.
C19
25