Panasonic KX-TGF973 Operating Instructions Manual page 90

Useful Information
Problem
The handset or base unit does
not ring.
I cannot make local calls with
the handset or base unit using
a cellular line.
I cannot make or answer
cellular calls with the handset
or base unit.
I can make and answer cellular
calls but cannot hear a sound.
I cannot switch cellular calls
from the unit to the cellular
phone.
I cannot make a call using a
landline.
I cannot use a cellular line.
The handset or base unit does
not ring using the cellular
phone's ringer tone even when
the ring as cell mode is turned
on.
When you receive a call for a
cellular line, the ringer volume
is very low.
For assistance, please visit http://shop.panasonic.com/support
90
KX-TGF97xUSA(en-us)_0928_ver121.pdf 90
Cause/solution
R The ringer volume for landline is turned off. Adjust the
ringer volume (page 25, 32, 56, 60).
R The ringer volume for cellular line is turned off. Adjust the
ringer volume (page 25, 32, 54, 60).
R The unit which is not selected to ring for cellular calls
does not ring. To change the selection, see page 21.
R Silent mode is turned on. Turn it off (page 63).
R The ringer volume is turned off by pressing and holding
0 ( ) on the handset. Press and hold 0 (
turn it on (page 25).
R You need to add your area code when making cellular
calls. Store your area code in order to automatically add it
to the beginning of the 7-digit phone number when
making cellular calls (page 23).
R Depending on the cellular phone's compatibility (page 6),
you may not be able to make or answer cellular calls even
if the cellular phone is connected to the base unit.
R Make sure that the CELL indicator lights up and the
cellular phone is connected to the base unit (page 22).
R Only 1 Bluetooth device can be used with the unit at a
time.
R The cellular phone is being used separately from your
system.
R The Bluetooth technology on your cellular phone may not
be functioning normally. Turn off and on your cellular
phone.
R Disconnect and reconnect the base unit AC adaptor and
try again.
R Your cellular phone may not support this feature. Refer to
the operating instructions of your cellular phone.
R The dialing mode may be set incorrectly. Change the
setting (page 18).
R The unit cannot be used to talk on 2 cellular lines at the
same time. Try again later.
R If answer by voice command is turned on, the units use
the preset ringer tones (CELL 1: Tone 2, CELL 2: Tone
4) when receiving calls. To change the setting, see
page 35.
R Ringer volume in "Ring as cell mode" depends on the
cellular phone Bluetooth output level specification. If ring
as cell mode is set to "On (with Talking CID)" or
"On (without Talking CID)", turn this feature off to
use the ringer tones of the handset and base unit
(page 21).
) again to
9/28/2022 11:24:43 AM