Recording; Settings For Recording - Sony DSR-1800A Operating Instructions Manual

Recording

Settings for Recording

26
Recording
This section describes the necessary settings and operations to perform
recording on this unit. The same settings and operations apply whether you are
using the unit as part of an editing system, for dubbing, or as a stand-alone
recorder.
For the necessary connections for recording and the settings not covered in this
section, see Chapter 5 "Connections and Settings" (page 75).
1
Video monitor
3
Note
When controlling this unit from an editing control unit connected to the
REMOTE connector, see "Remote control setting section" (page 16).
1
Power on the video monitor, then set its input switches according to the
signals input from this unit.
2
Set up the player to play back a tape.
Player (DSR-1600A/1600AP, etc.)
dB OVER dB dB OVER dB dB OVER dB dB OVER dB
0 0 0 0
0 0 0 0
-12 1 -12 1 -12 1 -12 1
-20 0 -20 0 -20 0 -20 0
-1 -1 -1 -1
-30 -30 -30 -30
-40 -40 -40 -40
-2 -2 -2 -2
48k44.1k32k
-60 1 -60 2 -60 3 -60 4 PB FS
Audio level meters
Input selection/audio mode
display section
dB OVER dB dB OVER dB dB OVER dB dB OVER dB
INPUT V:SDTI SDTI i.LINK
0 0 0 0
0 0 0 0
VIDEO COMPOSITE Y-R,B S VIDEO SDI SG
-12 1 -12 1 -12 1 -12 1
-20 0 -20 0 -20 0 -20 0 CH11/2 ANALOG AES/EBU SDI SG
AUDIO
-1 -1 -1 -1
-30 -30 -30 -30 ANALOG AES/EBU SDI SG
CH23/4
-40 -2 -40 -2 -40 -2 -40 -2
-60 1 -60 2 -60 3 -60 4 PB FS 48k44.1k32k REC MODE 2CH4CH
Recorder (DSR-1800A/1800AP)
7
A B
MARK
5 6
2
REMOTE button
4