Playback; Settings For Playback - Sony DSR-1800A Operating Instructions Manual

Playback

Settings for Playback

32
Playback
This section describes the settings and operations necessary to perform playback
on this unit. The same settings and operations apply whether you are using the
unit as part of an editing system, for dubbing, or as a stand-alone player VCR.
For the necessary connections for playback and the settings not covered in this
section, see Chapter 5 "Connections and Settings" (page 75).
Player (DSR-1800A/1800AP)
1
dB OVER dB
0
0
-12 1
-20 0
-1
-30
-40
-2
-60 1
1
Power on this unit by pressing on the
2
Power on the video monitor and set its switches as shown below.
Switch
75 Ω termination switch
Input switch
Video monitor
2
dB OVER dB dB OVER dB dB OVER dB INPUT V:SDTI SDTI i.LINK
0 0 0
0 0 0
VIDEO COMPOSITE Y-R,B S VIDEO SDI SG
-12 1 -12 1 -12 1
-20 0 -20 0 -20 0 CH11/2
ANALOG AES/EBU SDI SG
-1 -1 -1 AUDIO
-30 -30 -30
CH23/4 ANALOG AES/EBU SDI SG
-40 -40 -40
-2 -2 -2
-60 2 -60 3 -60 4 PB FS 48k44.1k32k REC MODE 2CH4CH
side of the POWER switch.
Setting
ON (or attach a 75 Ω terminator.)
Set according to the type of input signal from this
unit.