Page 2
WARNING 1. Must use ground nails, ropes, and expansions screws for whichever ground you install on for stability to avoid devastat- ing injuries for people inside or nearby and property damage caused by a collapsing gazebo. 2. Do not use this gazebo in high winds, heavy snow, or inclem- ent weather.
Page 3
ASSEMBLY INSTRUCTIONS 1. Two or more people are required for assembly. 2. A ladder and electric drill may be necessary. 3. Do not erect the structure in heavy winds or inclement weather. 4. Do not leave up this unit for extended periods of time, as it is not a permanent structure or designed to withstand sustained wind or rain.
Page 7
ASSEMBLY INSTRUCTIONS 2pcs 2pcs 2pcs 2pcs 4pcs 32pcs 120pcs When connecting B and B1 via P,C and C1 via P, make sure that 1 holes on part P (as shown in the picture) should be facing upwards. Do not install it upside down.
Page 18
ASSEMBLY INSTRUCTIONS 4pcs 4pcs 2pcs Before installing Parts R1/R2/R3, remove protective films (with side marks) on both the front and back sides. After removal, there will be no mark and minimal difference between the sides. Therefore, pay close attention to directions before removal.
Page 20
ASSEMBLY INSTRUCTIONS 2pcs 4pcs 4pcs 2pcs 4pcs 4pcs Before installing Parts Q/Q1/Q2, remove protective films (with side marks) on both the front and back sides. After removal, there will be no mark and minimal difference between the sides. Therefore, pay close attention to directions before removal.
Page 21
ASSEMBLY INSTRUCTIONS 2pcs 4pcs 4pcs Before installing Parts Q/Q3/Q4, remove protective films (with side marks) on both the front and back sides. After removal, there will be no mark and minimal difference between the sides. Therefore, pay close attention to directions before removal.
Page 23
ASSEMBLY INSTRUCTIONS 4pcs The other part has 8 holes hanging on Part C1. One part of the curtain has 7 holes hanging on Part B. The other part has 8 holes hanging on Part C. One part of the curtain has 7 holes hanging on Part B1.
Page 24
ASSEMBLY INSTRUCTIONS Pay attention to the sidewall curtain's installation position.
Page 25
ASSEMBLY INSTRUCTIONS 4pcs The other part has 8 holes hanging on Part C1. The other part One part of the has 8 holes hanging on Part C. netting has 7 holes hanging on Part B. One part of the netting has 7 holes hanging on Part B1.
Page 26
ASSEMBLY INSTRUCTIONS Note: Attach 1 to 2 to secure parts S (netting) and T (curtains) together. Attach 1 to 3 to secure the back curtain (T). Attach 1 to 3 to secure the front netting (S). Pay attention to the sidewall Hang the hook attached to netting's installation position.
Page 27
ASSEMBLY INSTRUCTIONS 12pcs 12pcs Installation Completed To improve wind resistance, be sure to complete this installation step. If expansion screws or ground nails are not installed,strong winds Cement surfaces may topple the gazebo. Expansion screws are essential for stability on cement surfaces, and ground nails are for grassy surfaces.
Page 28
Pure & Easy CONTACT US: If you have any questions about the installation of YITAHOME products, just contact us at +� (���) ���-���� from Mon-Fri �:�� AM-�:�� PM PST / Sat. �:�� AM-��:�� PM PST or e-mail us at after-sale.cs@hotmail.com Alternative method to contact us (amazon.com orders only)