Emptying The Dust Cup; Cleaning And Replacing The Filters - Shark VERTEX AZ1800 Series Owner's Manual

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, press release button on
top of the pod. Tilt dust cup away from wand,
then lift to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
access screen.
s h a r kc l e a n . c o m
Dust Cup
Release
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.

CLEANING AND REPLACING THE FILTERS

CLEANING FILTERS
Regularly rinse and replace the filters to
maintain your vacuum's suction power.
To prevent damage from cleaning chemicals,
rinse filters with cold water only. Allow all
filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being
drawn into electric parts.
IMPORTANT: DO NOT use soap when
cleaning the filters.
Filter
Door
Release
Filter Door
CLEAN HEPA FILTER EVERY YEAR
With the dust cup removed, press button on Filter Door. Pull forward and slide out to remove,
then take out HEPA Filter.
To reinstall, insert HEPA filter into unit and replace filter door.
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
CLEAN PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Filter
s h a r kc l e a n . c o m