Heat & Glo 6000CL-IFTLP-S Installation Manual page 60

Step 3. Left Refractory Installation
6. Steps for installation of left refractory side are the same
as right side. Repeat the same procedure as Step 2.
REFRACTORY REFRACTORY
PANEL MUST PANEL MUST
BE FLUSH WITH BE FLUSH WITH
LOWER FIREBOX LOWER FIREBOX
LIP LIP
Figure 6
60 Heat & Glo • 6000CL-IFT, 8000CL-IFT Installation Manual • 2504-980 Rev. Q • 11/21
Step 4. Top Refractory Installation
7. Using both hands, hold the top refractory panel with
the brick pattern facing down.
8. Insert the top refractory panel into the firebox and lift
it toward the top. Keep top refractory panel close to
upper firebox lip. This will allow for easier installation
due to the wider dimension of the front of the firebox.
Slide the top refractory panel in toward the back wall
of firebox, maintaining the same angle as the top sec-
tion of the side panels.
9. Lower the top refractory panel onto the side and back
refractory panels. There is a lip on the top panel that
allows it to sit on the top edge of the side panels.
Push tight against back refractory panel.
10. Installation is complete when top refractory panel is
set securely in place. Top refractory panel may need
to be pulled down to fit correctly. Chamfers should
properly fit together and gaps should be minimized
with correct installation.
NO GAPS NO GAPS
Figure 7