On Board Indication - Emerson Bettis XTE3000 Installation, Operation And Maintenance Manual

Section 3: PRO2000V4_RED Implementation
March 2022
3.2

On Board Indication

Figure 1
Slave Board #1
Five LEDs are mounted on the PRO2000v4_RED to give the following indications for field service.
LEDs indications are active only when jumper JP2 is closed.
DL1 (Red) Data Area Empty:
DL2 (Red) Base comm:
DL3 (Orange) Slave State:
DL4 (Green) Termination:
DL5 (Green) PROFIBUS:
DL6 (Green) Power:
More indications are given on local operator interface as described in Section 9.2, Node Report.
4
Installation, Operation and Maintenance Manual
LED DL1
LED DL2
LED DL3
Slave Board #2
ON when Data Area on interface card is not yet loaded
BLINK when Data Area is being read from base card
OFF when Data Area is completely loaded
ON when the communication between the base card
and the interface is not working properly
OFF when the communication between the base card
and the interface is correct
ON when the interface acts as an Primary Slave (i.e. it is the
interface with a valid communication with the Master)
BLINK when the interface acts as a Backup Slave and it is ready
(only for redundant configuration)
OFF when the interface is not communicating with any Master
ON when the on-board PROFIBUS termination has been inserted
OFF when the on-board PROFIBUS termination has not been inserted
ON when PROFIBUS communication has been established and the
interface has entered in DATA_EX state
ON when the interface is correctly powered
MDE 256 Rev. 1
Jumper J2
LED DL6
LED DL5
LED DL4
PRO2000V4_RED Implementation