Table Of Contents - Emerson Bettis XTE3000 Installation, Operation And Maintenance Manual

Installation, Operation and Maintenance Manual
MDE 256 Rev. 1

Table of Contents

Section 1: Introduction
Section 2: Operation and Storage
Section 3: PRO2000V4_RED Implementation
Section 4: PROFIBUS DP Description
Section 5: PRO2000V4_RED Power-Up
Section 6: Slave Redundancy (DP-V2)
Section 7: Wiring: Bus Terminations
Section 8: Master Controller (PLC) Commissioning
Section 9: Local Operator Interface Commissioning
Section 10: Data Exchange Mode (Cyclic Communication)
Table of Contents
Introduction............................................................................................................ 1
Operation and Storage............................................................................................ 2
3.1 Communication Features .............................................................................. 3
3.2 On Board Indication ...................................................................................... 4
4.1 RS485 Transmission Mode ............................................................................ 6
PRO2000V4_RED Power-Up.................................................................................... 8
6.1 Redundancy Structures ............................................................................... 11
Wiring: Bus Terminations...................................................................................... 12
8.1 GSD Installing ............................................................................................. 14
8.2 PRO2000V4_RED Interface ......................................................................... 21
9.1 Bus Control ................................................................................................. 24
9.2 Node Report ............................................................................................... 25
9.3 Bus Signal Failure Indication ........................................................................ 27
10.1 Cyclic Communication DPV0 ....................................................................... 28
10.1.1 Output Data (PLC to Device) ........................................................... 28
10.1.2 Input Data (Device to PLC) .............................................................. 29
10.2 Acyclic Communication DPV1 (MS2) ........................................................... 30
10.2.1 Nameplate ..................................................................................... 30
10.2.2 General Data and Command .......................................................... 31
10.2.3 Maintenance Information for PROFIBUS
Guideline Compliance (Read Only) ................................................. 33
Table of Contents
March 2022
i