Parkside 345138 2004 Instructions Manual page 26

GB IE
which the cutting tool may
come into contact with
hidden wiring or its own
cord. If the screw were to come
into contact with a live electrical
cable, metal parts of the appli-
ance could also become live
and cause an electric shock.
c) Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fire.
8) SAFETY INFORMATION
FOR USING LONG DRILLS
a) Do not work at a speed
higher than the maximum
permissible speed for the
drill. Higher speeds can cause
the drill to bend slightly when
rotating freely without contact
with the workpiece and can
also cause injury.
b) Always begin drilling at a
low speed and when the
drill is in contact with the
workpiece. Higher speeds can
cause the drill to bend slightly
when rotating freely without con-
tact with the workpiece and can
also cause injury.
c) Do not apply excessive
pressure to the drill. Only
apply pressure lengthwise
along the drill. Drills can
bend and break or cause a
26
loss in control, thus resulting in
injuries.
9) RESIDUAL RISKS
Even if properly operating and han-
dling this electric tool, some residual
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk of
serious or lethal injuries, we
recommend that persons with
medical implants consult their
doctor and the manufacturer
of their medical implant be-
fore operating the machine.
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for