Electrical Safety; Handling Safety; Installation Safety - Beko CM 8120 BMG User Manual

1.3 Electrical Safety

• Product should be unplugged during
installation, maintenance, cleaning and
repair procedures.
• If the power cable is damaged, it must
be replaced by the authorised service
in order to avoid possible risks.
• Do not tuck the power cable under
and behind the product. Do not place
heavy objects on the power cable. Do
not over bend, crush and touch the
power cable to sources of heat.
• Do not use an extension cord, multi-
plug or adaptor to operate your
product.
• The plug shall be easily accessible. If
this is not possible, a mechanism that
meets the electrical legislation and
that disconnects all terminals from the
mains (fuse, switch, main switch, etc.)
shall be available on the electrical in-
stallation.
• Do not touch the plug with wet hands.
• When unplugging the appliance, don't
hold the power cord, but the plug.
• Make sure the plug is not wet, dirty or
dusty.

1.4 Handling Safety

• Unplug the product before moving, re-
move the water outlet and water main
connections. Drain any water left in-
side the product.
• The product is heavy, do not move
alone. Do not hold extruding parts
such as the laundry loading door to lift
and move the product. The upper tray
should be tightly fixed for moving.
• Your product is heavy; it should be
carried carefully by two people if a
staircase is involved. It may cause in-
juries if your product falls on you. Do
not hit and drop the product while
carrying.
• Carry the product in an upright posi-
tion.
• Make sure that the hoses as well as
the power cable are not folded,
pinched or crushed after the product
is fitted into its place after installation
or cleaning procedures.

1.5 Installation Safety

• Check the information on the manual
and installation instructions to prepare
the product for installation and make
sure the electrical mains, clean water
mains and water outlet are suitable. If
not, call a qualified electrician and
plumber to have them make the ne-
cessary arrangements. These opera-
tions are the responsibility of the cus-
tomer.
• Check for any damages before in-
stalling the product. Do not go ahead
with the installation if the product is
damaged.
• Injuries may occur if hands are put
into uncovered slots. Close the holes
of the transportation safety bolts with
plastic plugs.
• Do not install or leave the product at
locations where it may be exposed to
external environment conditions.
• Do not install the product at locations
where the temperature drops below 0
ºC.
• Do not place the product on a carpet
or similar surface. It would create fire
hazard since it cannot receive air from
underneath.
• Place the product on a level and hard
surface and balance with the ad-
justable legs.
EN / 5