Panasonic CS/CU-HU12ZKY Series Operating & Installation Instructions Manual page 11

nanoe
To enjoy freshness and cleaner
environment
nanoe
• This is a combination operation together with
**nanoeX and nanoe-G (nanoe™ TECHNOLOGY).
• This operation can be turned ON or OFF manually
by pressing "nanoe" button.
• The operation can be activated even when the unit
is turned off. In this condition, the flap and fan
speed will operate based on remote control setting.
• If power failure occurs during the operation, this
operation will be resumed immediately after power
resumes.
FAN SPEED
To select fan speed
(Remote control display)
AUTO
QUIET
FAN
(Low)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
SWING SWING
To adjust airflow direction
(Remote control display)
(Vertical)
(Horizontal)
• Keeps the room ventilated.
• If AUTO air swing is set, the flaps swings
left/right and up/down automatically.
• The horizontal and vertical flap are fixed at the
predetermined position.
• Do not adjust the flaps by hand.
For faster cooling and a longer
JETSTREAM
air throw
JETSTREAM: Display on remote LCD
• This operation stops automatically after 1 hour.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airflow
direction.
• SLEEP, TIMER, JETSTREAM etc. functions will not
resume after power failure.
• In TIMER set conditions if there is power reset then
unit will start in stand by mode.
(Medium) (High)
To set the timer
To turn ON and OFF the unit at a preset time.
1 2
TIMER
ON OFF CANCEL
Select ON or OFF
timer
• Press the OFF
button.
Set the time
• Press OFF button again to
increase timer time in step
of "10" minutes.
OFF OFF OFF
Confirm
• Wait for "3" seconds to set timer.
*
• To cancel ON or OFF timer, press
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing ON or OFF
• * The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start
earlier (up to "15" minutes) before the actual
set time in order to achieve the desired
temperature on time.
Operation conditions
Use this air conditioner under the following
temperature range.
DBT : Dry bulb temperature
WBT : Wet bulb temperature
Note:
* Not applicable for "HU" series and AU18***4F model.
** Not applicable for "WU", "XU", "PU" & "AU" series.
Example:
OFF at 14:00
OFF
OFF
CANCEL
.
then wait for "3" seconds.
52 30
11