Hanging The Fan - Hinkley FINNIGAN Instruction Manual

HANGING THE FAN

REMEMBER
to turn off the power before you begin.
To properly install your ceiling fan, follow the steps below.
Sl ip the yoke cover,
trim ring
6
S lide the hanger ball onto the downrod, insert
the cross pin though the downrod and tighten.
7
Tighten the set screw
Lift ball/downrod/fan into hanger bracket
8
opening should fit in slot
opposite hanger bracket opening on b a ll. (Fig.
4)
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the
safety cable from the fan. Loop the safety cable around the
wood screw that was just attached to ceiling joist. Feed the end
of the cable into the clamp and pull as much cable through as
possible. Firmly tighten screw in the clamp. Cut off excess cable.
07 | hinkley.com
and canopy onto the downrod. (F ig. 3)
NOTE: The tab
Cross Pin
Hanger ball
Set screw
Hook-up (3) Wires
Downrod
Yoke Cover
Top of Fan Body
Fig. 3
Wood Ceiling Joist
Safety Cable Clamp
Safety Cable Loop
Wood Screw
And Washer
Safety Cable
Fig. 4
Ground Wire
Canopy
Trim Ring