Hinkley FINNIGAN Instruction Manual page 8

HANGING THE FAN
Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove ball pin;
remove ball. (Fig. 1)
Car efully support fan body (motor) in its st
2
with the mounting collar (where the wires c
upwa rd.
Loosen the two security set screws and remove the
3
downrod pin and cotter pin from the coupling on top of the
motor assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable
4
from the fan through the downrod. Thread downrod into
coupler until holes align. Insert downrod pin through holes
in mounting collar and downrod; clip cotter pin through
small hole in end of downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large
5
flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
06
| hinkley.com
yrofoa m packing
ome out) facing
Top of Fan Body
Cross Pin
Hanger
Ball
Set Screw
Fig. 1
Hook-up
(3) Wires
Downrod
Security Set Screws
Mounting Collar
Cotter Pin
Downrod
Safety Cable
Downrod Pin