Vivotek FD816B-H User Manual page 290

VIVOTEK
method addv4
addv6
delv4
delv6
ip <IP address>
index <value>
return <return page>
8.13 UART HTTP Tunnel Channel
Note: This request requires Operator privileges.
Method: GET and POST
Syntax:
http://<servername>/cgi-bin/operator/uartchannel.cgi?[channel=<value>]
-------------------------------------------------------------------------
GET /cgi-bin/operator/uartchannel.cgi?[channel=<value>]
x-sessioncookie: string[22]
accept: application/x-vvtk-tunnelled
pragma: no-cache
cache-control: no-cache
-------------------------------------------------------------------------
POST /cgi-bin/operator/uartchannel.cgi
x-sessioncookie: string[22]
content-type: application/x-vvtk-tunnelled
pragma : no-cache
cache-control : no-cache
content-length: 32767
expires: Sun, 9 Jam 1972 00:00:00 GMT
User must use GET and POST to establish two channels for downstream and upstream. The x-sessioncookie in GET
and POST should be the same to be recognized as a pair for one session. The contents of upstream should be
base64 encoded to be able to pass through a proxy server.
290 - User's Manual
Add IPv4 address into access list.
Add IPv6 address into access list.
Delete IPv4 address from access list.
Delete IPv6 address from access list.
Single address: <IP address>
Network address: <IP address / network mask>
Range address:<start IP address - end IP address>
The start position to add or to delete.
Redirect to the page <return page>after the parameter is assigned.
The <return page>can be a full URL path or relative path according to
the current path. If you omit this parameter, it will redirect to an
empty page.
(capability.nuart > 0)