Table of Contents
Advertisement
3.
Remove the purge cover (22) by inserting a probe at the entry point on the housing and lift the edge of the
cover. Slide the tool clockwise about the pivot point until cover comes loose. Make sure to hold the cover with
your hand to keep the cover from flying off.
4.
Remove diaphragm retainer (24) and diaphragm (23).
5.
To remove the C-clip (18) first align the clip slot with the lower circular mark in the housing as shown. Using the
small screwdriver, pry outward and downward slightly.
6.
Push the access plug (14) to remove it from the housing.
www.sherwoodscuba.com
Pivot Point
9
Advertisement
Table of Contents
