Table of Contents
Advertisement
DISASSEMBLY PROCEDURE
1.
Use a 3/4" (19mm) open end wrench to stabilize the inlet connector (9) and a 5/8" (16mm) wrench to rotate
the hose fitting nut counterclockwise to separate the hose assembly (26) from the inlet connector.
2.
Remove the tie wrap (17) and mouthpiece (25).
CAUTION – When performing the next step to remove the Purge Cover be careful to avoid placement
of the probe or screwdriver between the Housing and the Diaphragm Retainer. Incorrect placement of
the screwdriver may increase the risk of damage to the Diaphragm requiring replacement of the part.
www.sherwoodscuba.com
8
Advertisement
Table of Contents
