McConnel PA6085 Operator's Manual page 42

Reverse tractor squarely and centrally to the
machine - set tractor lower links to a height that
will permit attachment to lower frame attachment
points.
Adjust top link to position the stabiliser tongue
for attachment to the tractors top link clevis.
NOTE: Alternative tongues for stabilisers are
available for differing applications.
IMPORTANT: Rear of stabiliser tongue should be as close as possible to the bottom of the stabiliser
slot with the machine at rest on the ground – if required change the stabiliser lower attachment points
and/or clevis attachment position to achieve this setting. This is a vital requirement to ensure the
tongue is located at the slots mid-point when the machine is raised to the work position thus allowing
float in each direction.
1
Reverse fully in to attachment points then raise
the tractor linkage until it locks onto the lower
link balls on both sides of the machine.
Attach stabiliser tongue to highest suitable clevis
position that does not interfere with or foul tractor
components - secure with pin and lock pin.
23
3
2
2
1
3