Table of Contents
Advertisement
Post Delivery Assembly
To allow for a compact shipping state the
machine will be delivered with the tension
link disconnected from the rocker and the
stand legs retracted – these items will need
to be correctly installed before initial
attachment to a tractor; the procedure is as
follows:
Stand Legs
Raise the machine using suitable overhead
lifting equipment.
Lower stand legs and secure in position
using pins and locking pins – the hole
position selected should be at a height that
places the gearbox stub axle approximately
3" (75mm) below the height of the tractor's
PTO shaft when the machine is at rest on
the ground. Note the hole position used and
ensure the equivalent one is used on both
sides of the machine
Tension Link Attachment
Request assistance for this task.
Operate 'lift up' on machine controls
sufficient only for dipper arm to clear the
ground.
Pivot out the dipper arm until the tension
link can be connected and secure in
position with pin and fixings supplied.
Axle Mounted Machines
If the machine is axle
mounted,
connect
the
mounting arms to the
main frame using the nuts
and
bolts
supplied.
Tighten nuts when the
correct holes have been
determined.
See following page for
details of mounting hole
selection.
15
Advertisement
Table of Contents
