Viking VGIQ412-2RE Service Manual page 30

Service Diagnostics and Procedures
Infrared Rotisserie Burner (continued)
2. Locate rotisserie burner cover(s). Remove
screws securing igniter cover.
Rear View
Screws
3. Remove screws and rear access panel.
Remove screws securing burner(s).
© 2009 Viking Preferred Service
Igniter Cover
Screws
5. Remove burner from opening.
6. Reverse procedure to reassemble.
If burner fails to light, verify spark at igniter and gas
flow. If no spark at igniter, verify the igniter has
0 and no visual cracks. If igniter is proper and still
Ω
no spark, verify igniter wires and ignition module.
If wiring is good and 120 volts are proper at the
module, replace the module. If igniter is proper and
still no spark, verify igniter wires and spark module.
If wiring is good and the voltage is proper at the
spark module, replace the spark module.
Note: VGBQ532-3RE model shown
30