Page 1
Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com Outdoor Gas Grills F20456D EN (102908J)
Table of Contents IMPORTANT – Please Read and Follow! Important Information ________________________________________________________________________2 T-Series ______________________________________________________________________________________4 DANGER WARNING WARNING Dimensions (30” and 41”) _______________________________________________________________4 Specifications (30” and 41”) _____________________________________________________________5 FOR YOUR SAFETY FOR YOUR SAFETY Dimensions (53”)_________________________________________________________________________6 If not installed, operated and maintained in I I f f y y o o u u s s m m e e l l l l g g a a s s : : accordance with the manufacturer’s instructions, Specifications (53”)_______________________________________________________________________7...
General Information Built-In Information • Keep grill area clear and free from • A minimum of 6” (15.2 cm) from the sides, T-Series Grills: WARNING combustible materials, gasoline, and other or a minimum of 8” (20.3 cm) from the • When using a rear wall, locate the flammable vapors.
Ventilation for Built-In Installations When DANGER Gas and Electrical Connection Using an Enclosed LP-Gas Cylinder Not more than 5.00 inches from inside bottom of countertop. GAS CONNECTION GAS CONVERSION Verify the type of gas supply to be used, convert grill from natural 5.00 inch...
LP/Propane Tank Connection LP/Propane Tank Requirements Outdoor grills orificed with connector to the LP/Propane tank. Open the A dented or rusty LP/Propane tank may be valve outlet that is provided with the cylinder LP/Propane gas come equipped with a high tank valve and check the connection between hazardous and should be checked by your valve.
DANGER Leak Testing Although all gas connections on the grill are • Do not smoke while leak testing. leak tested at the factory prior to shipment, • Extinguish all flames. a complete gas tightness check must be • Never leak test with an open flame performed at the installation due to possible mishandling in shipment or excessive CAUTION...
Burner Adjustment Flames should be blue and stable with no Each burner is tested and adjusted at the yellow tips, excessive noise or lifting. If any of factory prior to shipment; however, variations in the local gas supply may make it necessary these conditions exist, check if the air shutter to adjust the burners.
Performance Checklist Rotisserie System The rotisserie motor is attached to the A qualified installer should carry out the WARNING following checks: mounting bracket located on the right side of the grill frame. The rotisserie motor must ELECTRICAL SHOCK HAZARD • All internal packaging removed. •...
Service & Registration Service & Parts Only authorized replacement parts may be used in performing service on the appliance. Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Record the following information indicated below.