Cleaning Instructions (Whipper Plate Assembly) - Curtis Primo Cappuccino PCGT3700 User Manual

CLEANING INSTRUCTIONS
Cleaning The Whipper Plate Assembly CAFEPC and PCGT Series - Weekly or As Needed
The following cleaning process requires a mild solution of dish-washing detergent and warm water, One-Pro
Beverage Equipment Cleaner (Curtis PN WC-79001) and food grade lubricant (Curtis PN WC-4916). Mix the One-
Pro cleaner at a ratio of 1 oz. (28 g.) per 5 gal. (19 L) of hot water (122°F/50°C min.).
The dispenser should be OFF. Turn the dispenser off by
turning the rear toggle switch to the OFF position.
1 Remove the dispensing spout from the whipper
chamber. Clean the inside using a narrow brush.
2 Pull the upper mixing cup forward and twist it up and to
the left to separate it from the lower mixing cup.
3 To remove the lower mixing cup, pull it up and forward to
free it from the hot water inlet.
4 Take hold of the whipper chamber. Turn it clock-wise to
free it from the mounting plate.
5 Pull the whipper propeller off of the motor shaft.
6 Wash, rinse, sanitize and air dry the whipper assembly parts using
the 3-sink method. Wash in the mild detergent solution, rinse in warm
clean water. Place the faucet parts in the One-Pro solution and allow
them to soak for 15 minutes. Then rinse thoroughly and air dry.
7 Clean the motor shaft with a cloth and mild detergent before
removing the mounting plate.
8 Twist the mounting plate clockwise and pull it off of the motor shaft.
IMPORTANT - Do not remove the mounting pillars to remove the
mounting plate.
9
10 Lubricate the center seal of the mounting plate with food grade
lubricant before reinstalling.
11 Reassemble the cleaned whipper assembly parts into the unit in
reverse order.
CAUTION: When replacing the propeller, line up the "D" shaped
mark on the propeller with the "D" shape on the motor shaft.
Failure to line up the propeller properly will cause it to fuse with
the shaft. This condition is not covered under the warranty.
CAFEPC, PCGT WHIPPER ASSEMBLY, CLEANING INSTRUCTIONS
Mounting
pillar
Hot water
inlet
Upper
mixing
cup
Lower
mixing
cup
WASH
RINSE
CI20
Motor Shaft
Mounting
plate
Propeller
Whipping
chamber
Spout
SANITIZE
031320A