Assembly - Bosch BDU314Y Owner's Manual

Fitting and removing the display
(see figure A)
A
(2)
1
(6) (5)
1
(5)
To fit the on-board computer (1), attach it to the
front edge of the display mount (5) in the direction of
travel, on the snap-in hook (6) on ❶ and press the
rear side of the on-board computer (1) onto the dis-
play mount (5) ❷.
To remove the on-board computer (1), pull it to-
wards you ❶ until you are able to lift off the on-board
computer (1) ❷.
A retaining strap can be secured to the bridge (9).
Note: The eBike switches off if you ride be-
low 1.9 mph and take the on-board computer out of
Bosch eBike Systems

Assembly

2
(9)
(2)
2
the holder. This does not apply to eBikes with assis-
tance up to 28 mph.
Inserting the Locking Plate (see figure B)
B
(10)
Note: Depending on the design/installation of the dis-
play mount, it may be the case that the removal
blocker cannot be used. The on-board computer must
be mounted.
Insert the locking plate (4) into the adapter shell (10)
from below until you hear the locking plate (4) click
into place.
From this point onwards, you can no longer remove
the on-board computer (1) from the display
mount (5) without removing the display mount (5)
from the adapter tray (10) by loosening the two fas-
tening screws (11).
Note: The locking plate (4) is not an anti-theft device.
English – 9
(5)
(11)
(4)
0 275 U07 3BK | (01.03.2023)