Cleaning The Milk Container; Cleaning The Hot Water/Steam Connection Nozzle - DeLonghi PrimaDonna Elite ECAM656.55.MS Instructions For Use Manual

2. Remove the water tank (A16) (fig. 3);
3. Open the infuser door (A18) (fig. 29) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 30);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 31), then push the PUSH symbol fully
in until it clicks into place;
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 32.
33

15.10 Cleaning the milk container

To keep the frother efficient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 34);
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (fig. 34) and pull it off upwards;
8. Once inserted, make sure
the two coloured but-
tons have snapped out
(fig. 33);
9. Close the infuser door;
10. Put the water tank back.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dish-
washer safe, placing them in the top basket of the
dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 35). If necessary, scrape the
groove with a toothpick;
5. Rinse inside the froth adjustment dial seat with running
water (fig. 36);
6. Check that the intake tube and spout are not clogged with
milk residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
15.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A9)
with a sponge to remove milk residues from the gaskets (fig.
22).
20
35
34
36