Installing The Appliance; Connecting The Appliance; Turning The Appliance On - DeLonghi PrimaDonna Elite ECAM656.55.MS Instructions For Use Manual

Hide thumbs Also See for PrimaDonna Elite ECAM656.55.MS:
Table of Contents

Advertisement

5.2 Installing the appliance

Important!
When you install the appliance, you should respect the follow-
ing safety warnings:
The appliance gives off heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm be-
tween the surfaces of the appliance and the side and rear
walls and at least 15 cm above the coffee maker.
Water penetrating the coffee machine could cause
damage.
Do not place the appliance near taps or sinks.
The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
Arrange the power cord in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).

5.3 Connecting the appliance

Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to a correctly installed and efficiently
earthed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
electrician.
5.4
Setting up the appliance
Please note!
Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
You should customise water hardness as soon as possible
following the instructions in section "17.
hardness".
1. Plug the power cord (C8) connector into the socket (A20) at
the back of the appliance and connect the appliance to the
mains electricity supply (fig. 1). Make sure the main switch
(A21) at the back of the appliance is pressed (fig. 2);
2. "SELECT LANGUAGE": Press the selection arrow (B2) corre-
sponding to the required language;
Follow the instructions indicated on the appliance display:
3. "FILL TANK WITH FRESH WATER": remove the water tank
(A16) (fig. 3), open the lid (A15) (fig. 4), fill to the MAX line
with fresh water (fig. 5), close the lid and put the tank back
in the appliance (fig. 6);
4. "INSERT WATER SPOUT": Check that the hot water/steam
spout (C6) is inserted on the connection nozzle (A9) (fig. 7)
and place a container holding a minimum of 100 ml under-
neath (fig. 8);
5. "WATER CIRCUIT EMPTY PRESS OK TO START" appears on
the display;
6. Press the "
ers hot water from the hot water spout (fig. 8) then goes
off automatically.
The coffee machine is now ready for normal use.
Please note!
The first time you use the coffee maker, you need to make
4-5 cups of coffee or 4-5 cappuccinos before it starts to give
satisfactory results.
The first time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit fills.
When making the first 5-6 cappuccinos, it is normal to
hear the noise of boiling water. After this, the noise be-
comes less.
To improve the performance of your appliance, we recom-
mend installing a water softener filter (C4) as described
in section "18. Water softener filter". If your model is not
provided with a filter, you can request one from De'Longhi
Customer Services.

6. TURNING THE APPLIANCE ON

Please note!
Before turning the appliance on, make sure the main switch
(A21) is pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
etting water
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A8) and is collected in the drip tray (A14) underneath. Avoid
contact with splashes of water.
To turn the appliance on, press the
9). The message "HEATING UP UNDERWAY PLEASE WAIT"
appears on the display.
When heating is complete, the message changes to:
"RINSING UNDERWAY, HOT WATER FROM SPOUTS". As
well as heating the boiler, this also heats the internal cir-
cuits by circulating hot water.
10
OK" button to confirm. The appliance deliv-
button (A7-fig.

Advertisement

Table of Contents
loading

Table of Contents