Changing The Mapping (All Six Days Models) - KTM 350 EXC-F 2021 Owner's Manual

17.4

Changing the mapping (All Six Days models)

Warning
Voiding of the government approval for road use and the insurance coverage If the combination switch is
mounted, the vehicle's road permit, if any, expires.
–
Only operate the vehicle in closed-off areas remote from public road traffic if the combination switch
is installed.
Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the TC button.
The mapping can also be changed during the ride.
–
Remove guide plate
–
Position the required guide plate on the grip tube.
Guideline
The label OUTSIDE must be visible. Marking
positioned at marking
Grey guide plate (79002014000)
Alternative 1
Black guide plate (79002014100)
Info
The gray guide plate opens the throttle valve more
slowly.
The black guide plate opens the throttle valve more
quickly.
The gray guide plate is mounted upon delivery.
102246-10
–
Clean the outside of the handlebar and the inside of the grip
tube. Mount the grip tube on the handlebar.
–
Attach the throttle cables to the guide plate and route cor-
rectly.
–
Position half-shells
Guideline
Screw, throttle grip
–
Slide on sleeve
V01803-10
movement.
Finishing work
–
Check the throttle cable play. (
TUNING THE ENGINE 17
4 5
from handle tube
B
.
3
, mount and tighten screws
M6 5 Nm (3.7 lbf ft)
1
and check the throttle grip for ease of
p. 139)
.
A
must be
2
.
141